Quick Boot Manager
By using quick boot manager, you can shorten boot time of Windows.
You can also set [Boot Mode] to [Fast] in the [Boot] menu of the Setup Utility (refer toBoot Menu).

Starting Quick Boot Manager

  1. Log on to Windows as an administrator.
  2. Click Start (Start) - [All Programs] - [Panasonic] - [Quick Boot Manager].
    If [User Account Control] is displayed, click [Yes].

Changing the Settings

  1. Start the Quick Boot Manager.
  2. Select [Easy quick boot mode] or [Detailed quick boot wizard].
  3. Add a check mark for the item you want to accept.
  4. Click [Finish] or [Next].
    • If the other setting screen appears, repeat step 3.
    • If [Enter Password] is displayed, input the Supervisor Password or the User Password of setup Utility.
  5. Click [OK].
CAUTION
- Setting 'Fast' in step 3 screen above will skip the [Panasonic] boot screen normally displayed immediately after the computer is turned on. The time required to display the Windows boot screen will become shorter.
Since the [Panasonic] boot screen is not displayed, press and hold «F2» or «Del» and turn the computer on to start the Setup Utility.

Boot training

By using this function, Windows learns reading files on boot to shorten the boot time.
To start this function, perform the following procedure.
If [Enter Password] is displayed during the following procedure, input the Supervisor Password or the User Password of setup Utility.
  1. Connect the AC adaptor.
  2. Start the Quick Boot Manager.
  3. Click [Boot training].
  4. Select the timing of performing boot training and the action after finishing boot training, and click [OK].
  5. Click [OK] on the message of the password.
NOTE
- While performing the boot training, do not touch the keyboard, touch pad, screen, external mice, etc.

To clear all settings

To clear all settings of Quick Boot Manager, perform the following procedure.
  1. Start the Quick Boot Manager.
  2. Click [Clear all settings].
  3. At the confirmation message, click [Yes].
  4. Click [OK].
  5. Click [Finish].
    If [Enter Password] is displayed, input the Supervisor Password or the User Password of Setup Utility.